Legal

THE INFORMATION PROVIDED BY XVERVE TECHNOLOGIES INC. “AS IS” AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL XVERVE TECHNOLOGIES INC. BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.

History

References

[]

UART mode

Any Signalyzer channels can be configured and used as standard full featured UART at logic levels of your design. The default channel configuration Signalyzer Tool is shipped with is the MSSP mode of FT2232 and you would need to change the mode prior using the UART.

To configure Signalyzer Tool channel to UART mode please follow these steps.

Open Device Manager. With right click of mouse select Properties of Signalyzer Tool, then select Advanced tab.

Put a checkmark next to Load VCP and press OK.

After this step disconnect Signalyzer Tool from PC and reinsert it back. After enumeration PC will detect USB Serial Port (Signalyzer) and assign COM port number. Please note, if you configuring Signalyzer Tool to UART mode for the first time you may be requested to specify the drivers, in this case point to the directory with the extracted driver files.

To return Signalyzer Tool channel back to any non-UART modes follow the same steps, but in this case deselect Load VCP option.